Good exposure

Nice course

very basic

GOOD.....

good

good

Good

Good

First part of the course was good, but I think it lacked of projects and really doing projects using the Arduino. Besides, the last week is only about debugging (with a lot of detail) and I don't think it makes much sense to go to a lot of detail on debugging when we haven't learnt yet how to do sketches complex enough so advanced debugging is necessary.The course felt too easy at times, and at others to complex (using very specific terminology , specially in the last week). That being said, I believe the lecturer was clear and engaging when presenting the material.

For an entry level course the C plus programming expectations jump considerably. While the quizzes and video lectures are helpful for understading both hardware and software, the final project doesn't seem to build on the I believed having basic familiarity with Arduino would help, but I was unable to complete the final project.

The teacher basically assumes you already know quite a bit, because he goes over the basics, but doesn't cover them in any detail. So if you're completely new to Arduinos, this course will not actually help

This course barely touches C programming. While explanatory about the Arduino functions and structure, It should have been spread into more weeks so that it could cover more.

Not a bad introduction, but if you already know a bit about programming you can get the same basics and learn more quickly with a book.

It is good starting course but it needs to move out from the beggining bits with something more useful and less theoretical

Not much practical oriented. Theory teaching is very vague and not able to understand much.

No forum, no support, and in the end I don't feel prepared for the assignments.

Too simple and lack of practice exercises!

Little hands on Arduino. Very theoretical

Muito bom pena que não tem no meu idioma

not enough detail

So superficial

Good

Good

In my honest opinion, 90% of this course content was totally irrelevant. The instructor focuses heavily on explaining stuff rather than how to do stuff. Furthermore, course title says "The arduino platform and C programming" but actually the course gives no sufficient attention to C nor arduino itself. Instead, it focused heavily on concepts that are not at all important to a programmer learning arduino and embedded systems in general such as UART, how data is sent serially and the steps towards creation of a hex file. In addition, no attention was given at all to actual arduino coding and not even a single relevant task was given.

The course is almost about nothing. It seems to me that the teacher didn't make enough preparations and make a lot of mistakes during the couse. After 8 weeks of Arduino-related courses I've got almost nothing new besides first 2 chapters of Arduino Starter Kit book.